+971 6 535 5550
DELLAS DEKTON, LAIPTAC & HARD PORECALIN CUTTING DISC
DELLAS DEKTON, LAIPTAC & HARD PORECALIN CUTTING DISC
|
SLAB NAME & LENGTH |
DIAMETER (mm) |
REVOLUTIONS (SPINDLE) |
INFEED (mm/min) |
FEED (mm/min) |
OUTFEED (mm/min) |
|
LAIPTEC (12 mm) |
350 |
1600 / 1800 |
400 / 500 |
1600/1800 |
400 / 500 |
|
400 |
1400 / 1600 |
||||
|
DEKTON (20mm) |
350 |
1600 / 1800 |
300 / 400 |
600 / 800 |
300 / 400 |
|
400 |
1400 / 1600 |
||||
|
NEOLITH (12 mm) |
350 |
1600 / 1800 |
400 / 500 |
1600 / 1800 |
400 / 500 |
|
400 |
1400 / 1600 |
||||
|
FLORIM (6 mm) |
350 |
1600 / 1800 |
400 / 500 |
1600 / 1800 |
400 / 500 |
|
400 |
1400 / 1600 |
||||
|
LAMINAM (12 mm) |
350 |
1600 / 1800 |
400 / 500 |
1600 / 1800 |
400 / 500 |
|
400 |
1400 / 1600 |
||||
|
SANTA MARGHERITA (20 mm) |
350 |
1600 / 1800 |
300 / 400 |
600 / 800 |
300 / 400 |
|
400 |
1400 / 1600 |
OPERATING PRECAUTIONS
- -While cutting, the disc must come out 2 mm out of the material
- -Use plenty of water while cutting, spray water towards the front of the disc plate, as close to the cutting area as possible
- -Make sure the cutting bench is in good condition. Otherwise put a rubber Surface between the bench and the material
For the 45° tilted cut, we recommend reducing the feed by approximately 50%
